POWER
310 watts RMS per channel into 8 ohms.
470 watts RMS per channel into 4 ohms.
Both channels driven from 20Hz to 20kHz at less than 0.2% total harmonic distortionFREQUENCY RESPONSE
20Hz to 20kHz ±0.2dB
-3dB at 70kHz DISTORTION
Typically <0.05% THD at rated power
0.1% THD and IM worst case prior to clipping CURRENT OUTPUT
100A short duration peak per channel
Fuse protected RISE TIME
Typically 5µs PHASE RESPONSE
+0° at 20Hz and -14° 20kHz HUM & NOISE
100dB below rated output 20Hz to 20kHz, A-weighted INPUT IMPEDENCE
47k ohms GAIN
RCA Inputs: 32dB
Balanced Inputs: 38dB POWER/CURRENT CONSUMPTION
900W
1.6A (370W) Class AB Idle
0.2A (46W) Standby DIMENSIONS
Height: 220mm (8 3/4 ")
Width: 500mm (19 3/4")
Depth: 455mm (18")Amplifier Configuration Selector (ACS) switch
The rear panel ACS switch allows for the amplifier to be configured for Stereo RCA or XLR modes. Remote Trigger Input
When connected to a preamplifier trigger output, the amplifier will switch out of Standby and be ready for use when the preamplifier is taken out of standby. Ground Lift Switch
This allows for the signal ground to be isolated from the main chassis earth. This can assist in resolving unwanted ground loops or hum due to duplicate ground paths in some systems. WBT and Neutrik Connectors
High quality WBT RCA and Neutrik XLR input connectors are fitted along with WBT output speaker terminals to ensure a low distortion interface between your cables and the amplifier. Auricap Capacitors
Audience AV supply the Auricap XO capacitors used in several key areas of the circuit. Siltech Wiring
Siltech premium 'G7' silver/gold wire provides a perfect connection between components to give clear, fast and detailed presentation of the music signal. Aluminium Construction
The aluminium construction provides a rigid non-magnetic housing to eliminate unwanted magnetic fields that can interfere with the sensitive audio signals.
| 
