Ready to listen to and enjoy. No work required. This amplifier is being offered as part of trade-in inventory of a local high end amplifier manufacturer.The L-309's condition is accurately indicated by the pictures. It was not dolled up or detailed in any manner beforehand but cleared for operation. A 3 prong IEC power socket has been installed. Any questions, please write. ~~~~ C$750 - includes postage to Canadian and CONUS destinations ~~~~ These amplifiers seems to sell for over the $1k mark based on my research. The price offered for this unit is very reasonable. Packaging will be carefully done. For American buyers no customs duty will be incurred (sub USD$800 threshold) More photos can be sent your way through email directly. A review on the amp by some happy owner: http://www.classic-audio.com/luxman-l309-p-453.html Interesting reading on the front end utility of this amplifier: https://www.diyaudio.com/forums/multi-way/172806-flat-correct-stereo-system-116.html?#post2513026 ---------------------------------------------------------------------- About the L-309: Manufactured between September 1973 to 1975, this collectible luxurious Luxman L-309 is rare and sought after which followed the L-308 and inaugurated Luxman's staple Linear Equalizer. The Linear Equalizer in the Luxman L-309 is a 5-step up or down "tilt" to the preset RIAA curve, rotating the 1kHz-centered frequency response up or down to provide more bass and less treble or more treble and less bass. There is too much compression and standardization today to justify a Linear Equalizer, but given the highly variable response curve of the recordings back then, this was a useful feature. The regular tone controls are Luxman's other staple NF controls with selectable center frequency. The circuit is a fully-complementary DC power amp section with dual-rail power-supply and 3-stage DC EQ circuit for the phono - Single-Stage, Duo-beta, plus-X and Circuit /S were for later years. Compared to the original L-308, the Luxman L-309 has an added back pot to attenuate the Main in input level and L/R Mic inputs with pull-on/off level pot instead of the tape 1 I/O jacks of the L-308. Bar power output, the rest is the same : 2-position low cut, 2-position high cut, low boost, stereo/L/R/Mono (L+R)/Reverse, 3-position phono, 1 impedance selector, tuner input level pot and 2-way dubbing/monitoring. Specifications--------- Main Section
RMS Power Output..........................2 x 75W (8 ohms, continuous, both channels driven)
..........................2 x 85W (8 ohms, continuous, single channel driven)
Power Bandwidth.............................5Hz to 50kHz (-3dB, 0.03% THD)
Frequency Response.......................10Hz to 50kHz, +/- 1dB
Total Harmonic Distortion.................<0.03% (8 ohms, 75W)
Intermodulation Distortion.................0.04% (8 ohms, 75W)
Residual Noise.................................0.5mV, 86dB
Damping Factor...............................40, 8 ohms
Input...............................................600mV, 40k ohms Preamplifier Section
Frequency Response........................10Hz to 50kHz (line input: -1dB)
Total Harmonic Distortion..................<0.03% (line input: 1V)
Inputs..............................................2.5mV / 90k-65k-50k ohms (phono 1)
...............................................2.5mV / 65k ohms (phono 2)
...............................................100mV / 150k ohms (aux 1 & 2)
...............................................100mV / 50k ohms (tuner)
Max Input Signal..............................300mV (phono ; 1kHz)
Signal-to-Noise Ratio.......................>65dB (phono 1 and 2) > 80dB (lines)
Bass Controls.................................+/- 8dB / 100Hz ; 150Hz turnover
..................................+/- 10dB / 100Hz ; 300Hz turnover
..................................+/- 12dB / 100Hz ; 600Hz turnover
Treble Controls................................+/- 12dB / 10kHz ; 1,5kHz turnover
.................................+/- 10dB / 10kHz ; 3kHz turnover
.................................+/- 8dB / 10kHz ; 6kHz turnover
Low Cut Filter..................................20Hz or 70Hz / 6dB/octave
High Cut Filter..................................7kHz or 12kHz / 6dB/octave
Low Boost Filter..............................100Hz, 6dB/octave General
Dimensions(w x d x h)......................49 x 32 x 17 cm
Weight............................................13kg
|