Less than six months use. These are my JBL Array 1000's that I purchased new in April 2016. They are a 3 way floor standing speaker that uses the Array 10" (250mm) driver. The top end uses the 045 Ti Ultrahgh-Frequency compresion driver and the 175 Nd-3 High Frequency compression driver. These are the same two drivers used in the JBL S4700 and S3900 speakers. Very, very similar in sound to the much liked and reviewed Stereophile Class A rated Array 1400. The Array 1000's did not get the press that the 1440's did, which is unfortunate. The Array 1000's are barely a step down from the 1400's. The main difference is they do not go quit as low. I still get good, flat bass into the high 20's in my room. The 1400's can be "over bassed" in some rooms. These speakers opened my eyes (ears) up to the JBL Synthesis speaker sound and what good compression driver/horns can do and sound like!! Now moving up the JBL chain.These speakers are in fantastic shape. I would rank these speakers between a 10/10 and 9/10. They have only been in my house and set up in one room location. The only flaw I see is one very, very small "nick" in the finish, less then 1/8" in size. It is located next to the upper left speaker grill mounting hole as shown in the picture. You have to look close to even see it and it can not be seen with the grill on. This was on the speaker when I unpacked it from the factory packing. I have all original boxes, packing, jumpers, manual, etc. Will ship to US only. I will except US Postal money orders, cashiers check, certified check, etc. only. Buyer to pay for shipping and insurance. Asking $3,395.00 or make best offer.
|
